Integra DTR-6.8 Zone 2—Continued, Setting the Powered Zone, The Zone2 menu appears

DTR-6.8_En.book Page 110 Wednesday, June 20, 2007 11:55 PM

Zone 2—Continued

Setting the Powered Zone 2

To use Zone 2, you must make this setting. It enables the speakers connected to the ZONE 2 SPEAKERS termi- nals so that they produce sound when Zone 2 is used.

1	Press the [Receiver] button fol-
	lowed by the [Setup] button.
	The main menu appears onscreen.

2 Use the Up and Down []/[ ] buttons to select “7. Hardware Setup,” and then press [Enter]. The Hardware Setup menu appears.

7. Hardware Setup

1. Remote Control

2. Zone2

3.Tuner

4.Analog Multich

5.HDMI

6.Network

3	Use the Up and Down [ ]/[ ]
	buttons to select “2. Zone2,” and
	then press [Enter].
	The Zone2 menu appears.
	7–2. Zone2
	Powered Zone2	Not Act
	Zone2 Out	Fixed

4 Use the Up and Down []/[ ] buttons to select “Powered Zone2,” and use the Left and Right []/[ ] buttons to select:

Not Act: ZONE 2 SPEAKERS termi- nals deactivated.

Act: ZONE 2 SPEAKERS termi- nals activated.

When Zone 2 is activated and turned on (see page 112), the speakers connected to the ZONE 2 SPEAKERS terminals output sound, but the speakers con- nected to the SURR BACK SPEAK- ERS terminals do not (when Zone 2 is activated but not used, the surround back speakers work as normal).

5	Press the [Setup] button.
	The setup menu closes.

Note:

This procedure can also be performed on the AV receiver by using its [Setup] button, arrow buttons, and [Enter] button.

110