Integra DTR-6.8 Listening to the Radio, Using the Tuner, Tuning into Radio Stations, found

DTR-6.8_En.book Page 60 Wednesday, June 20, 2007 4:16 PM

Listening to the Radio

Using the Tuner

With the built-in tuner you can enjoy AM and FM radio stations. You can store your favorite stations as presets for quick selection.

Listening to the Radio

Use the [Tuner] input selector button to select either AM or FM.

In this example, FM has been selected. Each time you press the [Tuner] button, the input source changes between AM and FM.

Band Frequency

(Actual display depends on country)

■ Manual Tuning Mode

1	Press the [Tuning Mode] button
	so that the AUTO indicator disap-
	pears from the display.
2	Press and hold the Tuning Up or
	Down [ ]/[ ] buttons.
	The frequency stops changing when
	you release the button.
	Press the buttons repeatedly to change
	the frequency one step at a time.

The North American models change FM frequency in

0.2MHz steps, 10 kHz steps for AM. For other models it’s 0.05 MHz steps for FM and 9 kHz steps for AM. In Manual Tuning mode, FM stations will be in mono.

Tuning into Radio Stations	Tuning into weak FM stereo stations
	If the signal from a stereo FM station is weak, it may be
	impossible to get good reception. In this case, switch to
	Manual Tuning mode and listen to the station in mono.

1 2

■ Auto Tuning Mode

1	Press the [Tuning Mode] button
	so that the AUTO indicator
	appears on the display.
2	Press the Tuning Up or Down
	[ ]/[ ] buttons.
	Searching stops when a station is
	found.

When tuned into a station, the TUNED indicator appears. When tuned into a stereo FM station, the FM STEREO indicator appears on the display, as shown.

FM STEREO

AUTO TUNED

60

■Tuning into Stations by Frequency

You can tune into AM and FM stations directly by enter- ing the appropriate frequency.

1	Press the [Receiver] button, fol-
	lowed by the [D. TUN] button.
	(Actual display depends on country.)
	The [Receiver] button flashes.

2	Within 8 seconds, use the num-
	ber buttons to enter the fre-
	quency of the radio station.
	For example, to tune to 87.5 (FM),
	press 8, 7, 5.
	Note: While the [Receiver] button is
	flashing, the input source cannot be
	changed by using the remote controller.