Integra DTR-6.8 Selecting XM Radio Channels, •Channel Search mode: select any channel, Notes

Models: DTR-6.8

1 126
Download 126 pages 2.06 Kb
Page 63
Image 63
Selecting XM Radio Channels

DTR-6.8_En.book Page 63 Wednesday, June 20, 2007 11:53 PM

Listening to the Radio—Continued

Notes:

RADIO ID cannot be selected in Category Search mode. You must select Channel Search mode (see below).

The following letters are not used in XM Satellite Radio IDs: I, O, S, F.

XM Satellite Radio will transmit a special signal to your AV receiver to activate the full channel lineup. Activation normally takes between 10 and 15 minutes, but during busy peak periods, you may need to leave the AV receiver turned on for up to an hour.

Selecting XM Radio Channels

There are three ways to select XM radio channels:

Channel Search mode: select any channel.

Category Search mode: select channels by category.

Direct tuning: enter channel number.

Note:

You cannot select Channel Search or Category Search

mode while the Tuning Arrow •Channel Search mode: select any channel. indicators are flashing, as tuning is in progress.

Number buttons

Manual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundD.TUN

Manual backgroundManual backgroundManual backgroundManual background Receiver

Enter

Channel Search Mode

1

Press the [Receiver] button, fol-

 

 

lowed by the [Enter] button to

 

select “Channel Search” mode.

 

 

 

 

 

 

 

 

Category Search Mode

1Press the [Receiver] button, fol- lowed by the [Enter] button to

select “Category Search” mode.

2

Use the Left and Right [

]/[

]

 

buttons to select a category, and

 

use the Up and Down [

]/[

]

 

buttons to select a channel in

 

that category.

 

 

Direct Tuning

You can select an XM radio channel directly by entering its number.

1

Press the [Receiver] button, fol-

 

 

lowed by the [D. TUN] button.

 

The [Receiver] button flashes.

 

 

 

 

 

 

 

 

2

Within 8 seconds, use the num-

 

 

ber buttons to enter the channel

 

number.

The channel is selected.

For example, to select channel #20, press 0, 2, 0, or 2, 0, [Enter].

Note:

While the [Receiver] button is flashing, the input source cannot be changed by using the remote controller.

2

Use the Up and Down [ ]/[ ]

 

buttons to select a channel.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Channel number Channel name

You can also use the Left and Right

[Manual background]/[Manual background ] buttons to select a category.

63

Page 63
Image 63
Integra DTR-6.8 Selecting XM Radio Channels, •Channel Search mode: select any channel, Listening to the Radio—Continued