Integra DTR-6.8 THX Audio Setup, The Speaker Setup menu appears, Repeat and 7 for each speaker

DTR-6.8_En.book Page 94 Wednesday, June 20, 2007 4:16 PM

Advanced Setup—Continued

7	Use the Up and Down [ ]/[ ]	2	Use the Up and Down [ ]/[ ]
			buttons to select “2. Speaker
	buttons to select “Channel,” and		Setup,” and then press [Enter].
	then use the Left and Right [	]/
			The Speaker Setup menu appears.
	[ ] buttons to select another
			2.	Speaker Setup
	speaker.
			1.	Speaker Settings
	Repeat step 6 and 7 for each speaker.
			2.	Speaker Config
			3.	Speaker Distance
			4.	Level Calibration
			5.	Equalizer Settings
			6.	THX Audio Setup

8	Press the [Setup] button.
	The setup menu closes.

Notes:

•When the listening mode is set to Direct, no effect will be produced.

•Depending on the input source or listening mode, the Equalizer settings may not produce the desired effect.

•This procedure can also be performed on the AV receiver by using its [Setup] button, arrow buttons, and [Enter] button.

THX Audio Setup

This setting is not set automatically by the Automatic Speaker Setup function (see page 52).

When the bi-amping connections (see page 22) have been made, this setting cannot be performed.

With the Surr Back Sp Spacing setting, you can specify the distance between your surround back speakers.

1	Press the [Receiver] Remote
	Mode button, followed by the
	[Setup] button.
	The main menu appears onscreen.

3	Use the Up and Down [ ]/[ ]
	buttons to select “6. THX Audio
	Setup,” and then press [Enter].
	The THX Audio Setup screen appears.
	2–6. THX Audio Setup
	Surr Back Sp Spacing	<1ft

4 Use the Left and Right []/[ ] buttons to specify the distance between your surround back speakers:

< 1 ft (< 0.3 m) (Default): Select this if your surround back speakers are between 0 and 1 foot (0–30 cm) apart. 1–4 ft (0.3–1.2 m): Select this if your surround back speakers are between 1 and 4 feet (0.3–1.2 m) apart.

>4 ft (>1.2 m): Select this if your sur- round back speakers are more than 4 feet (1.2 m) apart.

Note:

This setting is only available if the Surr Back Ch setting in the Speaker Config- uration is set to 2ch (page 89).

5	Press the [Setup] button.
	The setup menu closes.

Note:

•This procedure can also be performed on the AV receiver by using its [Setup], [Enter], and arrow but- tons.

94