Integra DTR-6.8 instruction manual 112, Using Zone, Controlling Zone 2 from the AV receiver

DTR-6.8_En.book Page 112 Wednesday, June 20, 2007 4:16 PM

Zone 2—Continued

Using Zone 2

This section explains how to turn Zone 2 on and off, how to select an input source for Zone 2, and how to adjust the volume for Zone 2.

Controlling Zone 2 from the AV receiver

1 2

1	To turn on Zone 2 and select an
	input source, press the [Zone 2]
	button repeatedly.

Alternatively, press the [Zone 2] button followed by an input selector button within 8 seconds.

Zone 2 turns on, the Zone 2 indicator lights up, and the ZONE 2 12V TRIG- GER OUT goes high (+12 V).

To select AM or FM press the [Tuner] input selector button repeatedly (On the North American model, you can also select XM or SIRIUS).

To select the same source as that of the main room, press the [Zone 2] button repeatedly until “Z2 Sel: Source” appears.

2	To turn off Zone 2, press the
	Zone 2 [Off] button.

Note:

While Powered Zone 2 is being used, listening modes that require surround back speakers (6.1/7.1), such as Dolby Digital EX, DTS-ES, and THX Select2 Cinema, are unavailable.

Controlling Zone 2 with the Remote Controller

On

Input

Selector

Zone 2

Level –/+

Note:

• To control Zone 2, you must press the remote control- ler’s [Zone 2] button first.

1	Press the [Zone 2] button, then
	point the remote controller at the
	AV receiver and press the [On]
	button.

Zone 2 turns on, the Zone 2 indicator lights up, and the ZONE 2 12V TRIG- GER OUT goes high (+12 V).

2	To select an input source for
	Zone 2, press the [Zone 2] button,
	followed by an Input Selector but-
	ton.

To select AM or FM press the [Tuner] Input Selector button repeatedly (On the North American model, you can also select XM or SIRIUS).

3	To turn off Zone 2, press the
	[Zone 2] button, followed by the
	[Standby] button.

112