Integra DTR-6.8 Setting the Zone 2 Out, Zone 2—Continued, The main menu appears onscreen

DTR-6.8_En.book Page 111 Wednesday, June 20, 2007 4:16 PM

Zone 2—Continued

.Setting the Zone 2 Out

If you’ve connected your Zone 2 speakers to a power amp with no volume control in Zone 2, as explained in “Using Another Amp in Zone 2” on page 109, you must set the Zone 2 Out setting to Variable.

When set to Variable, the ZONE 2 OUT L/R jacks work like pre outs.

1	Press the [Receiver] button fol-
	lowed by the [Setup] button.
	The main menu appears onscreen.

2 Use the Up and Down []/[ ] buttons to select “7. Hardware Setup,” and then press [Enter]. The Hardware Setup menu appears.

7. Hardware Setup

1. Remote Control

2. Zone2

3.Tuner

4.Analog Multich

5.HDMI

6.Network

3	Use the Up and Down [ ]/[ ]
	buttons to select “2. Zone2,” and
	then press [Enter].
	The Zone2 menu appears.
	7–2. Zone2
	Powered Zone2	Not Act
	Zone2 Out	Fixed

4	Use the Up and Down [ ]/[	]
	buttons to select “Zone2 Out,”
	and use the Left and Right [	]/
	[ ] buttons to select:

Fixed: The Zone 2 volume must be set on the amp in that zone.

Variable: The Zone 2 volume can be set on the AV receiver.

5	Press the [Setup] button.
	The setup menu closes.

Note:

This procedure can also be performed on the AV receiver by using its [Setup] button, arrow buttons, and [Enter] button.

111