Intel EK-KZPCM-UG manual 5 Device Specific Parameter Menu, RZ1DB-VW Setup

Chapter 3. Installing the KZPCM Host Adapter

Selecting any ID from 0 to 6 in the menu brings up a parameter setup menu for that device; if you select ID 7, SYM53C875, a global parameter table for all devices appears. Figure 3-5 shows the Device Specific Parameter Menu for ID 0, RZ1DB-VW; descriptions of the menu selections follow.

Figure 3–5 Device Specific Parameter Menu

RZ1DB-VW Setup

R………Sync Rate……………………………………………………………40 Mb/sec

W………Width (bits)……………………………………………………16

D………Disconnect…………………………………………………………ON

T………Read Write I/O Timeout (secs)………10

S………Scan for Device at Boot Time…………YES

L………Scan for SCSI LUNs……………………………………YES

Q………Queue Tags…………………………………………………………Enabled

F1……Help

F2……Restore Default Setup

ESC…Exit this menu

Use arrow keys to select from menu. Then press ENTER.

∙Sync Rate [R] – Changes synchronous transfer rate from the default of 40 Mb/sec to 20 Mb/sec or 10 Mb/sec. Normally left at default for maximum performance, but can be changed on a device-by-device or bus basis.

∙Width (bits) [W] – Selects 16-bit (WIDE) or 8-bit operation. Can be left at 16-bit for all devices; adapter will negotiate correct width upon connection to each drive.

∙Disconnect [D] – Allows the drive to disconnect from the host adapter during transfers. Should be left enabled for maximum performance.

∙Read Write I/O Timout (secs) [T] – Timeout value host adapter will wait for a read or write to complete to the target device. Should be left at default of 10.

∙Scan for Device at Boot Time [S] – Enables host to scan for the target device at boot time. Disabling scanning of devices that are not on the bus can speed up the boot process. Default is enabled for all targets.

∙Scan for SCSI LUNs [L] – Enables host to scan for the Logical Unit Numbers (LUNs), which are sub-devices behind a single target ID. Disabling

EK–KZPCM–UG. B01 3–5