Intel EK-KZPCM-UG manual Device Selections Menu

KZPCM PCI–to–Dual Channel Ultra SCSI and 10/100MB Ethernet Host Adapter

∙Parity [P] – Parity checking on the SCSI bus is enabled by default. Parity checking should not be disabled, due to the increased probability of undetected errors on the SCSI bus. If you are experiencing parity errors, check the termination of the bus, the total length of the SCSI bus, and the quality and condition of the SCSI cables.

∙Host SCSI ID [I] – SCSI ID for the selected channel or host adapter. Default is 7. The utility will not allow selection of an ID that is seen to conflict with another SCSI ID.

∙Scan Order [O] – Determines whether the SCSI bus is scanned from ID 0, in ascending order to ID 15, or from ID 15 in descending order to ID 0. Default is Low to High.

∙Help [F1] – On screen help utility. Provides help on current menu screen.

∙Restore Default Setup [F2] – Restores all settings on the current page to Factory Default Settings.

∙Exit this menu [ESC] – Returns to the Main Menu.

3.5Device Selections Menu

If you select Device Selections from the Utilities menu, the Device Selections menu appears (Figure 3-4).

Figure 3–4.Device Selections Menu

DEVICE SELECTIONS

	Sync	Data		Time	Scan	Scan	Queue
	Rate	Width	Disc	Out	Bus	LUNs	Tags
0.RZ1DB-VW	40	16	On	10	Yes	Yes	Enabled
1.Dev1 N/A	40	16	On	10	Yes	Yes	Enabled
2.Dev1 N/A	40	16	On	10	Yes	Yes	Enabled
3.Dev1 N/A	40	16	On	10	Yes	Yes	Enabled
4.Dev1 N/A	40	16	On	10	Yes	Yes	Enabled
5.Dev1 N/A	40	16	On	10	Yes	Yes	Enabled
6.Dev1 N/A	40	16	On	10	Yes	Yes	Enabled
7.SYM53C875	40	16	On	10	Yes	Yes	Enabled

D……………………………………Device Selections 8 – 15

F1…………………………………Help

ESC………………………………Exit this menu

Use arrow keys to select from menu. Then press ENTER.

3–4 EK–KZPCM–UG. B01