Removing the Cover

This procedure describes how to remove the cover from the server. Before proceeding, be sure you are thoroughly familiar with the information in “Before You Begin” at the front of this chapter. Refer to Figure 6 while performing this procedure.

1.Use a Phillips screwdriver and remove the screw (A) from the front edge of the cover.

2.Grasp the back edge of the cover and simultaneously pull from the back edge and push near the front until the cover slides out from under the edge of the server front panel.

3.Grasp the notch (B) in the front center of the cover and lift to remove the cover.

Replacing the Cover

This procedure describes how to replace the cover on the server. Before proceeding, be sure you are thoroughly familiar with the information in “Before You Begin” at the front of this chapter. Refer to Figure 6 while performing this procedure.

1.Position the cover on the chassis with the notched edge (B) facing the front and the slotted sides of the cover inside the chassis frame.

2.Grasp the back edge of the cover and simultaneously push from the back and top until the front edge of the cover slides all the way under the edge of the server front panel.

3.Use a Phillips screwdriver and the screw (A) removed in the previous “Removing the Cover” procedure to securely attach the cover to the chassis.

A

B

OMO9449

Figure 6. Removing/Replacing the Cover

26

Intel ISP1100 Internet Server Product Guide

Page 26
Image 26
Intel ISP1100 manual Removing the Cover, Replacing the Cover