Intel ISP1100 manual Installing the Processor, Removing the Processor Chip

Removing the Processor Chip

Perform this procedure to remove the processor chip from the socket. Refer to Figure 8 while performing this procedure.

1.Face the front of the server and grasp the end of the zero-insertion-force (ZIF) arm (A) on the left side of the processor socket.

2.Bend the ZIF arm slightly to the left until it disengages from the socket tab (B).

3.Swing the arm up until it stops in the straight up position. The processor chip is now loose in the socket.

4.Grasp the processor chip on the outside edges and lift it from the socket.

A

B

OMO9451

Figure 8. Removing the Processor Chip

Installing the Processor

This procedure describes how to install the processor on the server board. Before proceeding, be sure you are thoroughly familiar with the information in “Before You Begin” at the front of this chapter.

CAUTION

Processor must be appropriate: You can cause damage to the server if you install an incompatible processor. See Chapter 1 for the supported processor characteristics (note the thermal and power considerations).

For exact information about processor interchangeability, contact the supplier.

28 Intel ISP1100 Internet Server Product Guide