Intel ISP1100 manual Removing the Riser and Add-in Cards

Removing the Riser and Add-in Card(s)

Perform this procedure to remove the riser and add-in card(s) from the server board. Refer to Figure 21 while performing this procedure.

CAUTION

Do not attempt to remove an add-in card without first removing the riser card from the server board. If you do, you can damage the board(s) or connectors due to clearance limitations. If there are any add-in cards already installed, remove the riser and the attached add-in card(s) together as described in the following procedure.

1.Grasp the riser card, with add-in card(s) attached, at each end (A) and gently rock and lift until the riser releases from the server board connector (B).

2.Remove the riser and add-in cards from the server board.

A

B

OMO9459

Figure 21. Removing the Riser and Add-in Card(s)

Removing/Installing Server Components 41