Hardware Management Overview

Table 33. Ethernet Controller Port State LED

LED Status (L1 and L5)

Meaning

 

 

Off

No Status

 

 

Red/Green/Amber

Active status of user-defined function

 

 

NOTE: Refer to Figure 14 and Figure 15 for LED (L1 and L5) placement on the

Front Panel.

3.14.8Fibre Channel Port State LEDs

The MPCBL0001 SBC supports two Fibre Channel port state LEDs mounted on the front faceplate. The LEDs are green and yellow. When this LED is lit, it indicates the port state of each Fibre Channel port. LED states are shown in the table as follows:

Table 34.

Fibre Channel Port State LED (DS2, DS3)

 

 

 

 

 

 

Yellow LED Status (Fibre

Green LED Status (Fibre

Meaning

 

Channel 1, left)

Channel 2, right)

 

 

 

 

 

 

 

ON

ON

Power On

 

 

 

 

 

Flashing

OFF

Loss-of-Sync

 

 

 

 

 

ON

OFF

Signal Acquired

 

 

 

 

 

OFF

ON

On-Line

 

 

 

 

 

FLASH

FLASH

F/W Error

 

 

 

 

3.15FRU Payload Control

The MPCBL0001 implements the “FRU Control” command as specified in the PICMG 3.0 Specification. Through this command, the payload can be reset, rebooted, or have its diagnostics initiated.

The FRU payload can be controlled by a command line via the Intel NetStructure® MPCMM0001 Chassis Management Module (CMM). The following CMM commands are supported by the MPCBL0001.

Table 35. CMM Commands for FRU Control Options

FRU Control Options

MPCMM0001 equivalent command

 

 

Cold Reset

cmmset –l bladex –d frucontrol –v 0

 

 

Warm Reset

cmmset –l bladex –d frucontrol –v 1

 

 

Graceful Reboot

cmmset –l bladex –d frucontrol –v 2

 

 

Diagnostic Interrupt

cmmset –l bladex –d frucontrol –v 3

 

 

Note: The user may issue an RMCP command to control the FRU payload as well. Refer to Table 98 on page 165 for the associated IPMI command information.

Intel NetStructure® MPCBL0001 High Performance Single Board Computer

67

Technical Product Specification

Page 67
Image 67
Intel MPCBL0001 manual FRU Payload Control, Fibre Channel Port State LEDs, Ethernet Controller Port State LED