Intel MPCBL0001 manual Fibre Channel SFP Optical Transceiver Module

Connectors

4.2.3Fibre Channel Small Form-Factor Pluggable (SFP) Receptacle (J34 and J35)

AMP part number: 1367073-1

The MPCBL0001 SBC has two SFP receptacles that support either the copper or fiber module interface. Fibre Channel connector J34 and J35 are available at the front panel. See Figure 13, “MPCBL0001 SBC Connector Locations” on page 70 for its position on the board. See Table 44, “Fibre Channel SFP Pin Assignments” on page 81 for pinout information.

Table 43. Fibre Channel SFP Copper Transceiver Module (AMP, J34, J35)

USFibre Channel Connector (J34) Pin Assignments			Fibre Channel SFP Receptacle (J34, J35)
	Fibre Channel CONNECTOR
Pin #		Signal Name
1		Signal Ground
2		Transmitter Fault
3		Transmitter Disable Input
4		Module Definition 2
5		Module Definition 1
6		Module Definition 0
7		Rate Select (not implemented)
8		Loss of Signal
9		Signal Ground
10		Signal Ground
11		Signal Ground
12		Received Data Out Bar
13		Received Data Out
14		Signal Ground
15		Receiver Power Supply
16		Transmitter Power Supply
17		Signal Ground
18		Transmitter Data In
19		Transmitter Data In Bar
20		Signal Ground

4.2.4Fibre Channel SFP Optical Transceiver Module

Refer to the Intel NetStructure® MPCBL0001 Compatibility Report for a list of SFP optical transceivers that have been validated. The report can be downloaded from http://www.intel.com/design/network/products/cbp/atca/mpcbl0001.htm

80	Intel NetStructure® MPCBL0001 High Performance Single Board Computer
	Technical Product Specification