Features Overview
•
•Supports
The MCH I/O subsystems interface incorporates four hub interfaces. Each Hub interface is a point-
•The first hub link connects the MCH to the ICH3.
•The next two hub link interfaces connect the MCH to P64H2 components.
•The remaining hub link is unused.
2.2.2.2Intel® 82801CA I/O Controller Hub 3 (U7)
The Intel® 82801CA I/O Controller Hub 3 (IHC3) provides the legacy I/O subsystem and integrates advanced I/O functions. ICH3 features are listed below:
•IDE interface controller
•Three Universal Host Controller Interface (UHCI)
•USB host controllers supporting up to 6 ports (MPCBL0001 SBC implementation supports one port on the front panel)
•Integrated I/O APIC
•SMBus 2.0 controller
•LPC interface
•Watchdog timer #3 (see “Watchdog Timers (WDTs)” on page 62)
•PCI 2.2 bus interface supporting 32bit/33 MHz operation
•Connects to MCH through Hub Interface A (HI 1.5)
The MPCBL0001 SBC implements one USB port and does not use the ICH3 PCI connection.
2.2.2.2.1PCI Bus Master IDE Interface (J24)
The ICH3 acts as a PCI based, enhanced IDE,
•PIO and DMA transfer modes
•Mode 4 timings
•Supports Ultra ATA33/66/100 synchronous DMA
•Buffering for PCI/IDE burst transfers
•Master/slave IDE mode
•Support for up to two devices (Master/Slave) via a single primary IDE connector (MPCBL0001 SBC implementation supports one optional physical 2.5" IDE device)
Note: Incorporating an optional IDE Hard Disk drive may significantly impact the Reliability Specifications in Section 6.3.
18 | Intel NetStructure® MPCBL0001 High Performance Single Board Computer |
| Technical Product Specification |