Intel® Server System SR1500AL User’s Guide 43
Installing a Slimline Optical Drive or Internal USB Floppy1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information”.
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the front bezel if it is installed. For instructions, see “Removing the Front
Bezel”.
4. Remove the server system cover. For instructions, see “Removing the System
Cover”.
5. Insert the interposer board into the optical drive.
6. Obtain the optical drive and the drive tray.
7. Align the two holes on the left edge of the optical drive and interposer board with
the two metal tabs in the tray as shown in Figure 34 (see letter “A”).
8. Lower the opposite side of the optical drive into the tray until it clicks into place
(see letter “B”).
Figure 34. Installing an Optical Drive into the Drive Tray
9. Screw the interposer board into the carrier.
10. Insert the optical drive tray assembly into the server system as shown in Figure 35.
11. Verify that the blue release lever on the tray locks into place.
12. Obtain the cable from the accessory kit and install the cable to the interposer board
and the server board.
13. (Optional) For installing the optional USB floppy drive, note the location of the
backplane USB connector and refer to the documentation that came with the
device.
TP02147
A
B