Invacare PANTHER LX-4, LYNX LX-3 REMOVING/INSTALLING the Batteries with Cables Figure, Removing

BATTERIES/CHARGING

PROCEDURE 4 BATTERIES/CHARGING

This Procedure Includes the Following:

Removing/Installing the Batteries with Cables

Replacing the Batteries

Charging the Batteries

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely - otherwise, injury or damage may result.

REMOVING/INSTALLING THE BATTERIES WITH CABLES (FIGURE 1)

NOTE: To install batteries, reverse the following procedure.

NOTE: When removing/installing batteries keep all foreign objects, especially metal, clear of battery terminals.

REMOVING

WARNING

Turn Power OFF and remove key from ignition.

Where applicable, ALWAYS use a battery lifting strap when moving a battery. It is the most convenient method. It also helps to prolong the life of the bat- tery.

DO NOT tip the batteries. Keep the batteries in an upright position.

The use of rubber gloves and chemical goggles is recommended when working with batteries.

Top Battery

Fastening Strap

Retaining

Battery Ring

RearLifting Strap

Sub-Frame

Battery Wiring Harness		Red Connector
Red		Black
		Connector
Connector
		Rear
Controller		Sub-Frame
Wiring	Black
Harness		Batteries
	Connector

NOTE: Hardware is in included with batteries.

NOTE: Only Model LYNX SX-3 battery cable assemblies shown for clarity.

FIGURE 1 - REMOVING/INSTALLING THE BATTERIES WITH CABLES

1.Turn Power OFF and remove key from ignition.

2.Remove the seat from the scooter. Refer to REMOVING/INSTALLING THE SEAT in PROCEDURE 5 in this manual.

3.Remove the rear shroud. Refer to REMOVING/INSTALLING THE REAR SHROUD in PROCEDURE 9 in this manual.

4.Disconnect top battery fastening strap and pull through retaining ring.

Invacare Scooters 26 Part No. 1090132 Rev F