Invacare PANTHER MX-4, PANTHER LX-4, LYNX LX-3PLUS Transport Procedure, Cable Side View

TRANSPORT

TRANSPORT PROCEDURE 10

8.For Panther MX-4 Models Built Before 10/00 - Without Delta Tillers (FIGURE 3):

WARNING

When reassembling scooter, ensure retaining pin is properly engaged in the hand brake cable. Otherwise, injury and/or damage may result.

A.Pull the retaining pin that secures the hand brake cable assembly together (DETAIL "A").

B.Remove the hand brake cable from the retaining tab located underneath the front shroud (DETAILS "B" & "C").

NOTE: Note the position of the locknut in relation to the frame tab for proper reinstallation. When re-assembling the hand brake cable assembly, the locknut must be positioned in front of the frame tab (DETAILS "D" & "E").

C. Remove the threaded end of the hand brake cable from the frame tab of the rear sub-

frame. DETAIL "A"		DETAIL "D" - REMOVING HAND
Rear		BRAKE CABLE
Sub Frame	Retaining Pin	Threaded End
		of Cable Assembly
	Hand Brake
	Cable Assembly

DETAIL "B"
	Frame Tab of Rear
	Sub-Frame
	DETAIL "E" - INSTALLING HAND
Retaining Tab	BRAKE CABLE ASSEMBLY
	Locknut
Hand Brake Cable	Threaded End
	of Hand Brake
DETAIL "C" - HAND BRAKE
	Cable Assembly
CABLE - SIDE VIEW
Rear

Hand Brake Cable

Frame Tab

Rear Wheel

NOTE: Side view shows location of Hand Brake Cable.

FIGURE 3 - TRANSPORTING THE SCOOTER - FOR PANTHER MX-4

MODELS BUILT BEFORE 10/00 - WITHOUT DELTA TILLERS

Invacare Scooters 52 Part No. 1090132 Rev F