TRANSPORT
PROCEDURE 10 | TRANSPORT |
This Procedure Includes the Following:
Transporting the Scooter
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely - otherwise, injury or damage may result.
TRANSPORTING THE SCOOTER (FIGURES 1 AND 2)
DISASSEMBLING THE SCOOTER
NOTE: To reassemble the scooter, reverse the following steps.
1.If applicable, remove the front basket. Refer to REMOVING/INSTALLING THE FRONT BASKET in PROCEDURE 11 of this manual.
2.Fold the back down. Refer to FOLDING/UNFOLDING THE BACK in PROCE- DURE 6 of this manual.
3.Remove the seat. Refer to REMOVING/INSTALLING THE SEAT in PROCEDURE 5 of this manual.
4.FOR ZOOM-3 MODELS ONLY - proceed to STEP 10.
5.Remove the rear shroud. Refer to REMOVING THE REAR SHROUD in PROCEDURE 9 in this procedure of the manual.
6.Remove the batteries with cable assemblies. Refer to REMOVING/INSTALLING THE BAT- TERIES W/CABLES in PROCEDURE 4 of this manual.
7.FOR ALL MODELS EXCEPT
A. For Models Built Without Delta Tillers:
1.Disconnect the BLUE connector of tiller wiring harness from BLUE connector of controller wiring harness (DETAIL "A").
2.Disconnect the YELLOW
connector of tiller wiring harness from YELLOW connector of controller wiring harness (DETAIL "A").
NOTE: In newer models (After 10/00), wiring harnesses from tiller to controller and connectors have been consolidated for ease of use.
B.For Models Built With Delta Tillers:
Disconnect the ORANGE connector of tiller wiring harness from ORANGE connector of controller wiring harness (DETAIL "B").
C.If applicable, remove the tiller wiring harness from the wire supports attached to the controller (DETAIL "A").
Invacare Scooters | 50 | Part No. 1090132 Rev F |
