Invacare LYNX SX-3 Replacing Tiller Angle Adjustment Lever Figure, Replacing Headlight Lightbulbs

OPTIONS/REPLACEMENT PARTS PROCEDURE 11

REPLACING TILLER ANGLE ADJUSTMENT LEVER (FIGURE 8)

NOTE: The tiller angle adjustment lever is NOT available on ZOOM-3.

1.Adjust the tiller so that the position of the tiller is in-between adjustment holes.

NOTE: This adjustment allows the plunger to be fixed in the fully extended position.

2.Remove the retaining ring.

3.Remove the pin that secures the adjustment lever in place.

4.Remove the adjustment lever from the plunger.

5.Install NEW adjustment lever onto plunger.

Seat	Pin	Plunger
			Tiller
Lever
			Adjustment
			Holes
Retaining
	Ring
	Position tiller in-between		Adjustment
	adjustment holes		Holes
	(STEP 1)

FIGURE 8 - REPLACING TILLER ANGLE ADJUSTMENT LEVER

OPTIONS/REPLACEMENT PARTS

6.Install pin through adjustment lever and plunger and secure in place with retaining ring.

7.Adjust tiller to one (1) of the three (3), or five (5) adjustment holes. Refer to TILLER ANGLE ADJUSTMENT in PROCEDURE 8 of this manual.

REPLACING HEADLIGHT LIGHTBULBS

MODELS LYNX LX-3 AND PANTHER LX-4 (FIGURE 9)

1.Remove the two (2) mounting screws that secure the headlight assembly to the housing.

2.Remove the plug from the headlight assembly.

3.Remove the EXISTING lightbulb from the plug.

4.Install the NEW lightbulb into the plug.

5.Reinstall plug into headlight assembly.

6.Resecure headlight assembly to the housing with EXISTING mounting screws. Securely tighten.

LYNX LX-3 AND PANTHER LX-4

Housing Mounting Screws

Lightbulb

Plug

Headlight Assembly

FIGURE 9 - REPLACING

HEADLIGHT LIGHTBULBS MODELS LYNX LX-3 AND PANTHER LX-4

Part No. 1090132 Rev F 59 Invacare Scooters