SEAT
PROCEDURE 5 | SEAT | |
|
|
|
ADJUSTABLE HEIGHT SEAT POST (FIGURE 4)
WARNING
Ensure that the seat height adjustment pin is properly engaged and locked. Otherwise, injury and/or damage may result.
DO NOT use the stability knob to adjust the seat height. It is NOT designed to support the weight of the user. Otherwise, injury to the user and/or damage to the scooter may result.
1.Remove the seat. Refer to REMOVING/INSTALLING THE SEAT in this procedure of the manual.
2.Remove the stability knob located on the front of the frame post.
3.Remove the rear shroud. Refer to REMOVING/INSTALLING THE REAR SHROUD in PROCEDURE 9 of this manual.
4.Disengage and remove the seat height adjustment pin from the seat post.
5.Adjust the seat post to the desired height adjustment.
6.Reinstall the seat height adjustment pin through the frame post and seat post.
7.Secure the seat height adjustment pin by performing the following steps:
A.Swivel the pin lock until it is parallel to the pin .
B.Bend the end of the pin lock and position it over the end of the pin (DETAIL "A").
8.Reassemble scooter by reversing STEPS 1-3.
ALL other models
1. Remove the stability knob located on | Adjustable |
| |
Height Seat |
| ||
the front of the frame post. |
| ||
Post | Seat | ||
| |||
CAUTION |
| Height | |
| Adjust- | ||
When the seat height adjustment pin |
| ||
| ment Pin | ||
is removed, the weight of the seat |
| ||
|
| ||
assembly MUST be supported to | Frame | Pin Lock | |
prevent the seat from falling onto | Post | ||
the frame. | DETAIL "A" | ||
| |||
2. Disengage and remove the seat height |
| Bend End of | |
adjustment pin from the seat post. |
| ||
| Pin Lock AWAY | ||
3. Adjust the seat assembly into the |
| ||
| From Pin | ||
frame post to the desired height |
|
| |
adjustment. | FIGURE 4 - ADJUSTING THE SEAT | ||
| |||
4. While holding the seat assembly in | HEIGHT - ADJUSTABLE HEIGHT | ||
place, install the seat height adjustment |
| SEAT POSTS | |
pin through the frame post and seat post. |
|
| |
5.Secure the seat height adjustment pin by performing the following steps:
A.Swivel the pin lock until it is parallel to the pin .
B.Bend the end of the pin lock and position it over the end of the pin (DETAIL "A").
Invacare Scooters | 36 | Part No. 1090132 Rev F |
