PARTS

PROCEDURE 11

OPTIONS/REPLACEMENT PARTS

 

 

 

REMOVING/INSTALLING THE CRUTCH/CANE HOLDER (FIGURE 4)

NOTE: The Crutch/Cane Holder, Safety Flag, and Oxygen Holder all install into the accessory tube; ONLY one (1) of these may be installed at a time. These accessories are NOT available on the ZOOM-3.

OPTIONS/REPLACEMENT

NOTE: To remove, reverse the following procedure.

WARNING

The installation of the crutch/cane holder onto the back of the scooter seat significantly increases the length of the scooter. When turning the scooter or swiveling the scooter seat, it is important to take note of this increased length - otherwise, injury and/or damage to the

surrounding property may result.

Seat

Crutch/

Cane

Holder

Hook

 

 

Mounting

Accessory

 

Screw

Base

Tube

 

FIGURE 4 - REMOVING/

INSTALLING THE CRUTCH/CANE

HOLDER

INSTALLING

1.Install the crutch/cane holder into the accessory tube located on the back of the seat.

2.. Install mounting screw to secure the crutch/cane holder in place. Securely tighten.

3. Align slot on base with hook on crutch/cane holder and slide base down into position.

REMOVING/INSTALLING THE SAFETY FLAG (FIGURE 5)

NOTE: To remove, reverse the following procedure.

WARNING

The installation of the safety flag onto the back of the scooter seat significantly increases the length of the scooter. When turning the scooter or swiveling the scooter seat, it is important to take note of this increased length - otherwise, injury and/or damage to the surrounding property may result.

Seat

Safety

Flag

Accessory Mounting

BracketTube Screw

FIGURE 5 - REMOVING/

INSTALLING THE SAFETY FLAG

INSTALLING

1.Install the bracket into the accessory tube located on the back of the seat.

2.Install mounting screw to secure the bracket in place. Securely tighten.

3.Install safety flag into bracket.

Invacare Scooters

56

Part No. 1090132 Rev F

Page 56
Image 56
Invacare PANTHER LX-4 REMOVING/INSTALLING the CRUTCH/CANE Holder Figure, REMOVING/INSTALLING the Safety Flag Figure, Parts