JVC HR-S9400U manual Recording Features

Recording Features

OSD

1 2 3

4 5 6

7 8 9

EN41

Record One Program While Watching Another

1	ENGAGE TV MODE
	During recording...
	● Press TV/VCR. The VCR's VIDEO indicator goes out.
	(If you are using the RF connection (☞ pg. 6) to view
	the output from your VCR, the TV broadcast being
	recorded disappears.)
	● If you are using the AV connection (☞ pg. 6) or
	S-VIDEO connection (☞ pg. 7) to view the output
	from your VCR, change the TV's input mode from AV
	to TV.

C.RESET

0

SELECT CHANNEL FOR VIEWING

DISPLAY

Display Tape Remaining Time

DISPLAY COUNTER

INFORMATION

1 Press OSD.

All indications corresponding to the VCR's current status are displayed for 5 seconds. The counter display remains on the screen indicating the elapsed time.

DISPLAY TAPE REMAINING TIME

2 Press DISPLAY until "REMAIN" appears on screen. The approximate tape remaining time appears on the TV screen and VCR display panel.

●The tape remaining time is calculated based on the tape speed (SP or EP) being used. The indicated remaining time is only an estimate.

●Press DISPLAY to change the on-screen display from REMAIN to COUNT and vice versa; and to show counter reading, channel number, clock time or tape remaining time on the front display panel. Then channel number will not be displayed when the VCR is playing a tape.

EXIT THE DISPLAY

3 Press OSD again.

NOTES:

●"SUPERIMPOSE" must be set to "ON", or the on-screen display will not appear (☞ pg. 31).

●Near the beginning of the tape, the tape remaining estimate may be inaccurate. However, the estimate becomes more accurate as the tape comes closer to the end.

●Depending on the type of tape used, the tape remaining time reading may not appear right away, or may not be correct. "--:--" may sometimes appear, or the display may blink on occasion.

●The tape remaining time indication is not accurate when using VHS-C tapes with VHS-C adapter.

2 Use the TV’s channel selector to set the channel you want to watch.

Display Elapsed Recording Time

RESET COUNTER TO ZERO

1 Before recording starts, press C.RESET. The counter resets to zero and displays the exact elapsed time as the tape runs.

DISPLAY ELAPSED TIME ON SCREEN

2 During recording, press OSD at any time to see the elapsed time. All indications corresponding to the current status of the VCR are displayed for 5 seconds. The counter display remains on the screen indicating the elapsed time. Press OSD again to remove the display.

●Make sure "SUPERIMPOSE" is set to "ON" (☞ pg. 31).

●The indications are not be recorded.

●Press DISPLAY to change to the COUNT display if REMAIN is displayed.