JVC HR-S9400U manual VCR Plus+ Timer Programming, Enter Pluscode Number, EN Timer Recording

46ENTIMERRECORDING(cont.)

VCR Plus+

Timer

Programming

●Before VCR Plus+ Timer programming, see "VCR Plus+ Setup" on page 20.

●Turn on the TV and select the VCR channel 3 or 4 (or AV mode).

8

	1	2	3
NUMBER	4	5	6
	7	8	9
CANCEL		0

OK

MENU

ILLUMI GUIDE

When Using The Illumi-Guide Feature

●Buttons light or blink on the remote control for approximately 10 seconds. If the button or buttons extinguish during timer programming, press ILLUMI GUIDE and the button or buttons previously lit or blinking come back on. If the button or buttons do not re-light or start blinking again, press MENU as many times as necessary to return to the normal screen and extinguish all illuminated buttons, and re-perform the timer programming procedure from the beginning.

●If for some reason the remote control's signal is not received by the VCR, press MENU as many times as necessary to return to the normal screen and extinguish all illuminated buttons, and re-perform the timer programming procedure from the beginning.

Timer recording allows you to program the VCR to automatically record a program which will be broadcast at some future time.

The timer record function can be programmed using VCR Plus+ or On-Screen Timer Programming. (☞ pg. 48)

During VCR Plus+ and on-screen programming, the Illumi- Guide feature tells you which button on the remote control must be pressed next by lighting the relevant buttons. The Illumi-Guide feature is activated by the ILLUMI GUIDE button on the remote control. The Illumi-Guide feature is only active when the remote control's TV/CABLE/DBS/VCR switch is set to "VCR". (Illumi-Guide is an optional help feature which makes programming easier. It is not necessary to use Illumi-Guide to program the VCR.)

1	LOAD A CASSETTE
	Make sure the record safety tab is present.
	● The VCR’s power comes on automatically.

ACCESS VCR PLUS+ SCREEN

2	To use the Illumi-Guide	VCR PLUS+
	feature press ILLUMI
	GUIDE. The MENU, REW,
	PLAY and FF buttons will

light.

Press MENU on the remote

control.PRESS NUMBER KEY(0-9)

PRESS (MENU) TO MAIN MENU

●The clock must be set in

order to access the VCR Plus+ screen. If you haven’t set the clock, the Main Menu screen appears when you press MENU. Refer to page 8 for the Advanced Auto Clock Set procedure or page 9 for the clock setting procedure.

●If you are using a PRIMESTAR DBS receiver, you may not be able to access the VCR PLUS+ screen. When this happens, set "DBS RECEIVER OUTPUT" to "OFF" (☞ pg.24), then press MENU on the remote control.

●If you are using the Illumi-Guide feature, the following buttons will light up: NUMBER keys (0 – 9), CANCEL and MENU.

ENTER PLUSCODE NUMBER

3 Press the appropriate NUMBER keys to enter the PlusCode number printed in the TV listings for the TV program you wish to record.

●To make corrections, press CANCEL and input the correct PlusCode number.

●If the PlusCode number you input is incorrect, "ERROR" may appear on the screen to advise you of the error. This happens when the PlusCode number is for a program which has already passed. "ERROR" is displayed for about 4 seconds and the VCR Plus+ screen reappears (step 2).

●If you are using the Illumi-Guide feature, OK blinks when the following buttons are lit: NUMBER keys (0 – 9), CANCEL and MENU.