JVC HR-S9400U manual Edit To Or From Another, Load Cassettes, Engage Tape Dubbing, Start Recorder

54EN

EDITING(cont.)

You can use your VCR as the player or the recorder.

Edit To Or

From Another

VCR

Player	AUDIO OUT
		Your VCR

VIDEO OUT	S-VIDEO OUT
Audio/Video	S-Video
cable
(supplied)	cable
	(supplied)
VIDEO IN	S-VIDEO IN

Recorder	Another VCR
	AUDIO IN

Advantages Of S-VHS VCRs

You can edit from VHS to S-VHS, from S-VHS to VHS, or from S-VHS to S-VHS.

●From VHS to S-VHS (VIDEO-VIDEO connection): Record VHS playback signals in the S-VHS mode. Although the picture quality is inherently limited by that of the original, the edited tape has better picture quality than those made by VHS-to-VHS editing.

●From S-VHS to VHS (VIDEO-VIDEO connection): Because the picture quality of the source material is very high, the edited tape has better picture quality than those made by VHS-to-VHS editing.

●From S-VHS to S-VHS (S-VIDEO connection): All signals will be transferred without degradation.

1		MAKE CONNECTIONS
		Connect an AV cable between the player’s VIDEO OUT
		and AUDIO OUT connectors and the recorder’s VIDEO
		IN and AUDIO IN connectors.
		● If using another VCR with an S-VIDEO input or
		output connector, it is recommended to use the S-
		VIDEO connection to minimize picture degradation
		while editing.
		● When using your VCR as the recorder and a monaural
		VCR as the player, connect the player’s AUDIO OUT
		connector to the AUDIO IN L connector on the recorder.
2		LOAD CASSETTES
		Insert the playback cassette into the player and the
		cassette to be recorded on into the recorder.
		SET RECORDER’S INPUT
3		MODE
		Set to AUX. With this VCR, press NUMBER key “0” (AU
		appears on the front display panel in place of a channel
		number).
		NOTE:
		When using this VCR as the recorder, be sure to select the
		correct AUX input connector (depending on which input
		connectors you use) at the Aux Input Screen. To select the
		correct AUX input connector, follow steps 4, 9 – 11, 15
	from the "Edit From A Camcorder" section, ☞ pg. 52.
		ENGAGE TAPE DUBBING
4		MODE
		Follow steps 4, 9, 13 – 15 from the "Edit From A
	Camcorder" section (☞ pg. 52)
5		START PLAYER
		Set to its play mode.
		NOTE:
		If the player is equipped with a superimpose/OSD
		disable feature then set "SUPERIMPOSE" to OFF before
		pressing PLAY (☞ pg. 31).
6		START RECORDER
		Set to its record mode.

NOTES:

●It is not possible to set both "TAPE DUB MODE" and "DYNAMIC CONTRAST" to ON.

●Be sure to set "TAPE DUB MODE" back to "OFF" when you finish editing.

●If you use a cable box or a DBS receiver connected to one of the VCR's auxiliary input connectors and if you have used this VCR as the recording deck for editing, be sure to select again the required input at the AUX Input screen when you finish editing.