JVC HR-S9400U manual DBS Receiver Control, To VCR, Connect Controller, DBS receiver

DBS Receiver Control

Suggested Location

Place the DBS (Direct Broadcast Satellite) receiver on top of the VCR. Attach the VCR's Controller to the top of the VCR with the Controller’s transmitter pointed towards the DBS receiver's remote sensor.

Attention:

The Controller can also control a cable box. If both a DBS receiver and a cable box are used, position the controller so its signal reaches the remote control sensors of both the DBS receiver and cable box.

DBS receiver

Your VCR	Controller
	(suggested locations)
	DBS receiver

Controller

Transmitter
Connected to	Connected
	to VIDEO/
ANTENNA IN	AUDIO IN

Your VCR

CABLE

BOX

About Your DBS Receiver

This VCR has two separate methods to control your DBS Receiver.

●The VCR's Wireless Remote Control Unit can control your DBS Receiver.

This eliminates the need for a separate DBS Receiver Remote Control Unit.

●The VCR's Controller can also control your DBS receiver. This allows the VCR to change your DBS receiver's channel number during timer recording.

Each method must be set up separately. To set up the VCR's Remote Control unit, refer to page 62. To set up the Controller go to page 24.

EN23

The following procedure is required if you receive satellite channels through a DBS (Direct Broadcast Satellite) receiver and you want your VCR to change to receiver's channels during timer recording.

The VCR can control the DBS Receiver during timer recording using its Controller.

NOTES:

●The Controller can automatically change the DBS Receiver channels when the VCR has been programmed using On- Screen Timer Programming (☞ pg. 48).

Because satellite programming does not use PlusCode; the Controller can not change the DBS Receiver channels during VCR Plus+ Timer Recording.

●If a cable box is used simultaneously, it is recommended to connect the DBS receiver to your VCR using A/V inputs.

Situate And Connect

Controller

1		SITUATE CONTROLLER
		Place the Controller so that the path between its
		transmitter and the DBS receiver's remote sensor is
		unobstructed.
2		ATTACH CONTROLLER
		Fasten securely using the supplied adhesive strips.
		CONNECT DBS RECEIVER
3		TO VCR
		The connection method depends on the type of DBS
		receiver you have.
		If your DBS receiver has AUDIO and VIDEO OUT
		connectors . . .
		. . . connect them to the AUDIO and VIDEO IN
		connectors on your VCR; if you use the input connec-
		tors other than the rear panel AUDIO and VIDEO OUT
		connectors, be sure to select the correct external input
		mode as described in step 4, 9 – 11, 15 on page 52. Set
	the VCR to channel "AU" to use the DBS receiver.
		If your DBS receiver doesn’t have AUDIO and VIDEO
		OUT connectors . . .
		. . . connect the antenna output connector on the DBS
		receiver to the ANTENNA IN connector on the rear of
		your VCR.
		Set the VCR tuner to the same channel as DBS receiver
		RF output. (See page 24 also.)
		NOTE:
		Refer to your DBS receiver's instruction manual during
		connection.
		CONNECT CONTROLLER
4		TO VCR
		Connect to the CABLE BOX connector on your VCR.