JVC RX-DP10VBK manual 2Turn the knob counterclockwise, 3Insert the speaker signal cable, Powered

Basic connecting procedure

1 2 3 4

Note:

You can connect two pairs of front speakers—one pair to the FRONT 1 SPEAKERS terminals, and the other pair to the FRONT 2 / SUB ROOM SPEAKERS terminals.

The speakers connected to the FRONT 2 / SUB ROOM SPEAKERS terminals can be used as follows:

•As the second front speakers in the main room

•As the front speakers in the sub-room when using the Multi-room operations. (See page 17.)

CAUTION:

1Cut, twist and remove the insulation at the end of each speaker signal cable (not supplied).

2Turn the knob counterclockwise.

3Insert the speaker signal cable.

4Turn the knob clockwise.

Use only the speakers of the SPEAKER IMPEDANCE indicated by the speaker terminals.

IMPORTANT for the FRONT 1 SPEAKERS connection:

To obtain the best possible output power from the receiver, and to prevent the receiver from being overheated, the receiver has the SPEAKER LOAD SELECTOR which has to be set as follows:

•Set it to the “HIGH” position when the impedance of the front speakers connected is within the range of 8 Ω to 16 Ω.

•Set it to the “LOW” position when the impedance of the front speakers connected is within the range of 4 Ω to 6 Ω.

Front speakers 1	Center speaker
Right / Left

	FRONT 2 /
FRONT 1 SPEAKERS
	SUB ROOM SPEAKERS

CAUTION :

SPEAKER

IMPEDANCE

LOW HIGH 46 8 16

SPEAKER	RIGHT	LEFT	RIGHT	LEFT
LOAD SELECTOR

CAUTION :

SPEAKER IMPEDANCE 816

	CENTER	SURROUND
SPEAKER		SPEAKERS

RIGHT LEFT

SURROUND BACK

SPEAKERS

+

–

RIGHT LEFT

Right / Left	Right / Left
Surround speakers	Surround back
	speakers

Right / Left

Front speakers 2

Connecting a subwoofer

You can enhance the bass by connecting a subwoofer. Connect the input jack of a powered subwoofer to the SUBWOOFER PREOUT jack on the rear panel, using a cable with RCA pin plugs (not supplied).

	FRONT
	SUB
	WOOFER	CENTER
	SURR
Powered	SURR
subwoofer	BACK
	R	L
		PREOUT
		8