JVC RX-DP10VBK manual Press the desired button, Set the LEARN/TRANSMIT, Main Room/Sub Room

To use the stored signals

When you want to use the stored signals, follow the procedure below.

IMPORTANT:

To operate the other component(s) using this remote control—

•Aim directly at the remote sensor(s) on the target component(s).

–This remote control can send signals at a distance of 7 m (23 feet).

OR

•You can also use the IR signal transmitter connected to this receiver.

–Place the IR signal transmitter so that it is aimed at the remote sensor(s) on the target component(s).

You can operate the other component(s) through the remote sensor on this receiver.

When using the remote control:

–Set the MAIN ROOM/SUB ROOM (LEARN/TRANSMIT) selector to “MAIN ROOM” or “SUB ROOM” correctly.

1.Set the LEARN/TRANSMIT (MAIN ROOM/ SUB ROOM) selector to “TRANSMIT (MAIN ROOM/SUB ROOM).”

LEARN TRANSMIT	LEARN TRANSMIT
MAIN ROOM SUB ROOM	MAIN ROOM SUB ROOM
For the main room	For the sub-room

operationsoperations

2.Press one of the source selecting buttons (or CONTROL repeatedly) to select the desired remote control operation mode (source).

DVD	DVD MULTI	PHONO	CD
VCR 1	VCR 2	TAPE/MD	CDR
TV/DBS	VIDEO	FM	AM

3. Press the desired button.

TV/CATV/DBS		VCR 1
				/ REW	PLAY	FF/
STANDBY/ON		STANDBY/ON		DOWN	TUNING	UP
				REC	STOP	PAUSE
			EFFECT
1		2	3			TV/VIDEO
			ROOM SIZE	TV VOL CHANNEL
4		5	6
			LIVENESS
7/P		8	9
			WALL
10		0	+10
RETURN	FM MODE		100+

SET

DVD

MENU

Notes:

•When you press TV/CATV/DBS (STANDBY/ON), set the TV operation mode selector correctly.

•To use the following buttons, you can skip step 2 above.

–VCR1 (STANDBY/ON), TV VOL +/–, TV/VIDEO, DVD MENU

•To use the following buttons, press DVD MENU first.

–SET, % / Þ / @ / #

To erase the stored signals

After erasing the stored signals, preset signals are resumed and you can operate JVC’s components again.

1. Set the LEARN/TRANSMIT

(MAIN ROOM/SUB ROOM)	LEARN TRANSMIT
selector to “LEARN.”
	MAIN ROOM SUB ROOM

2.Press and hold EXIT, then press one of the source selecting buttons from which you want to erase the stored signals.

DVD	DVD MULTI	PHONO	CD
EXIT

and	VCR 2	TAPE/MD	CDR
VCR 1
TV/DBS	VIDEO	FM	AM

LEARN

“CLEAR” appears on the display, and all the signals stored in the selected remote mode (source) are erased at the same time.

Notes:

•You cannot erase a signal assigned to a particular button only. Storing a new signal to a particular button erases the previously stored signal.

•To erase the stored signals for “CD DISC,” first press CONTROL to select “CD DISC,” then press CONTROL again while holding EXIT this time.

\ EXITand

3.Set the LEARN/TRANSMIT (MAIN ROOM/ SUB ROOM) selector to “TRANSMIT (MAIN ROOM/SUB ROOM)” to finish the erasing procedure.

LEARN TRANSMIT	LEARN TRANSMIT
MAIN ROOM SUB ROOM	MAIN ROOM SUB ROOM
For the main room	For the sub-room
operations	operations

73