JVC RX-DP10VBK manual Troubleshooting, Problem, Possible Cause, Solution

Troubleshooting

Use this chart to help you solve daily operational problems. If there is any problem you cannot solve, contact your JVC service center.

PROBLEM	POSSIBLE CAUSE	SOLUTION
The display does not light up.	The power cord is not plugged in.	Plug the power cord into an AC outlet. (See
		page 16.)
The buttons and controls on the front	The Multi-room function is not set	• Press MAIN ROOM ON/OFF for the main
panel do not work.	correctly.	room operations.
		• Press SUB ROOM ON/OFF and SUB
		ROOM CONTROL for the sub-room
		operations.

No sound from the speakers in the main room.

Speaker signal cables are not connected	Check speaker wiring and reconnect if
properly.	necessary. (See page 8.)
The SPEAKERS 1 and SPEAKERS 2/	Press SPEAKERS 1 and SPEAKERS 2 /SUB
SUB ROOM buttons are not set correctly.	ROOM correctly. (See page 23.)
An incorrect source is selected for the	Select the correct source for the main room.
main room.
Muting is activated for the main room	Press MUTING to cancel the mute.
source.	(See page 24.)
An incorrect input mode (analog or	Select the correct input mode (analog or
digital) is selected.	digital). (See page 23.)
Connections are incorrect.	Check connections.
	For analog connections, see pages 9 to 13.
	For digital connections, see page 14.

No sound from the front speakers in the	Speaker signal cables are not connected	Check speaker connection and reconnect if
sub-room.	properly.	necessary. (See page 17.)
	Main/sub setting for the speakers	Set the main/sub setting for the speakers
	connected to the FRONT 2/SUB ROOM	correctly to use them as the sub-room front
	terminals are not set correctly.	speakers. (See page 40.)
	Amplifier connected to the SUB ROOM	Turn on the amplifier.
	PREOUT is not turned on.
	An incorrect source is selected for the	Select the correct sub-room source.
	sub-room.
	Muting is activated for the sub-room	Press MUTING to cancel the mute.
	source.	(See page 30.)
	Connections are incorrect.	Check connections.
		For analog connections, see pages 9 to 13.
The sub-room speaker connected to the	The Surround/DSP mode is used for the	Cancel the Surround/DSP mode in the main
FRONT 2/SUB ROOM SPEAKERS	main room.	room.
cannot be activated.
Surround cannot be used for the main	Sub-room sound is activated (the SUB	Deactivating the sub-room sound will allow
room sources.	ROOM indicator is lit on the display).	you to use the Surround in the main room.
CD tracks are skipped, tape is rewound,	When the same source is selected both for	This is normal, not the malfunction of the unit.
or radio station is changed	the main room and the sub-room, the	Selecting different sources for the main room
unintentionally.	source in one room affects the source in	and the sub-room will avoid these troubles.
	the other room.
The receiver does not work correctly as	Main room and sub-room operations are	If this happens, perform the same operation
you operate it.	done at the same time.	again.

Continued on the next page.

74