JVC RX-DP10VBK manual Power amplifier Power amplifier, Connecting Audio/Video Components

Enhance your audio system

You can use this receiver as the pre-amplifier (control amplifier) when you connect power amplifiers to the PREOUT jacks on the rear panel, using cables with RCA pin plugs (not supplied).

•Connect the white plug to the audio left jack, and the red plug to the audio right jack.

Left front speaker Right front speaker

Power amplifier

Connecting Audio/Video Components

You can connect the following audio/video components to this receiver. Refer also to the manuals supplied with your components.

Audio Components	Video Components
• Turntable	*
	• DVD player
• CD player*	• TV*
• Cassette deck	*
	• DBS tuner
or MD recorder*	• VCRs (VCR1* and VCR2)
• CD recorder*	• Video camera

*You can connect these components using the methods described in “Analog connections” (below) and in “Digital connections” (see page 14).

RIGHT

FRONT

Center speaker

Power amplifier

LEFT

Analog Connections

Audio component connections

Use the cables with RCA pin plugs (not supplied).

•Connect the white plug to the audio left jack, and the red plug to the audio right jack.

CAUTION:

If you connect a sound-enhancing device such as a graphic equalizer between the source components and this receiver, the sound output through this receiver may be distorted.

SUB WOOFER

SURR

SURR

BACK

CENTER

Turntable

If a ground cable is provided for your turntable, connect the cable to the

AUDIO

RIGHT LEFT

PHONO

CD

PREOUT

Power amplifier

Power amplifier

screw marked (H) on the rear panel.

Turntable To audio output

OUT

(REC)

TAPE

MD

IN

(PLAY)

OUT

(REC)

CDR

IN

(PLAY)

FRONT

	DVD
SUB	CENTER
WOOFER

SURR (REAR)

R DVD L

Left surround	Right surround
speaker	speaker
Left	/ Right

Surround back speakers

Note:

The above connection is for a turntable with an MM (moving-magnet) type cartridge.

Any turntables incorporating a small-output cartridge such as an MC (moving-coil) type must be connected to this receiver through a commercial head amplifier or step-up transformer. Direct connection may result in insufficient volume.

9