TV MEASUREMENT
CHANNEL DISPLAY AND ENTRY
To measure the level of a reception signal, you must first enter the desired channel.
The following channels can be set:
• | Band I/III | CH 01 to CH 12 in 7 MHz raster |
• | Band IV/V | CH 21 to CH 69 in 8 MHz raster |
• | Special channel | S 01 to S 20 in 7 MHz raster |
• | Special channel | S 21 to S 41 in 8 MHz raster |
These details refer to the default Standard B/G only. For information on the other standards please see the technical appendix.
COMMAND OVERVIEW FOR TV CHANNEL ENTRY
Switch to desired TV reception
or |
|
|
|
|
| ... | Enter channel |
|
|
|
| Confirm entry |
|
|
or | ... | Enter | channel | (automatic |
|
| confirmation) |
| |
|
| Switch to special channel |
| |
| and | Change channels in intervals |
| |
Example
To enter channel S 28:
Press 
.
LC display:
•Special channel: S 28
•Level: 62.5 dBµV
•Operating mode: Digital cable TV (D=digital)
Note
Ensure that the correct standard has been set. The default setting is Standard B/G.
FREQUENCY DISPLAY AND ENTRY
To measure the level of a reception signal, you must first enter the desired video carrier frequency.
The frequency can be entered from 48 MHz to 858 MHz in 50 kHz intervals.
41
