Installation Menu

You should only make changes in this menu if the receiver is connected to a different receiving system with different properties or if changes have been made to the receiving system.

You should therefore carefully follow the instructions for your satellite system. However, before each change you should note the settings on the form at the end of this operating manual.

You reach the “DiSEqC[UFO] Setup” menu using the 

keys and the key in the Installation menu.

22 kHz Signal

This menu option is used to specify whether the 22 kHz signal is to be used to switch between the upper and lower frequency ranges for a satellite (low/high) or between two satellite positions.

Tone Burst and DiSEqCTM Signal

If more than four control criteria are requried in a receiving system, a

DiSEqC™ control signal is required.

Which of the setting options - Tone Burst or DiSEqC™ - is required depends on the components of the receiving system.

You should therefore refer to the descriptions of the existing components (switching matrices) of the receiving system.

Switching states for setting:

 

Switching states for setting:

 

Switching states for setting:

 

22 kHz Signal

----------->

High/Low

22 kHz Signal

----------->

Pos. A/B:

22 kHz Signal

----------->

Pos. A/B:

and

 

 

and

 

 

and

 

 

Tone Burst

----------->

Pos. A/B:

Tone Burst

----------->

Opt. A/B:

Tone Burst

----------->

High/Low

Low

22 kHz

Off

Pos

Tone Burst

22 kHz

Low

Tone Burst

0

High

22 kHz

On

 

 

 

High

Tone Burst

1

 

 

 

1

0

Off

 

 

 

Pos. 1

Tone Burst

0

2

0

On

Pos. 1

22 kHz

Off

Pos. 2

Tone Burst

1

3

1

Off

Pos. 2

22 kHz

On

 

 

 

4

1

On

 

 

 

DiSEqCTM

If the receiver is connected to a DiSEqC™ switching matrix, set the menu option to “On”.

The switching criteria and the input assignment of the DiSEqC™ switching matrices must be observed. You should therefore follow the description of the switching matrices or contact the engineer who installed the receiving system.

DiSEqCTM Repeat

If the receiver is operated in a receiving system with two or more

DiSEqC™ switching matrices connected in series (cascaded), the

DiSEqC™ command must be repeated.

In this case, set the DiSEqC™ Repeat menu option to “1” or “2”.

Default setting: “Off”

57

Page 57
Image 57
Kathrein UFD 170 manual KHz Signal, Tone Burst and DiSEqCTM Signal, DiSEqCTM Repeat