Installation Menu
UFO®mini
Remote Frequency
UFO®micro
“Reset” does not delete the pre-programming.
In a “subscriber controlled processing system”, the input frequency of the receiver is a fi xed setting. The “subscriber controlled processing system” transmits the signals at this frequency. The reception parameters for programme selection are communicated to the receiving system by a DiSEqC™ command and set.
The setting that has to be selected depends on the design of the “subscriber controlled processing system”.
If you have set the “UFO®mini” menu option to “On”, use this menu option to make the setting from the transmission frequency.
For the transmission frequency to be set, refer to the installation manual for the “subscriber controlled processing system”.
It is essential that you follow the instructions in the “subscriber controlled processing system ” installation manual.
The setting for this menu option is also designed for operation of the receiver in a processing system.
The return path of the coaxial cable is used for control and communication between the receiver and the Kathrein UFO®micro system. If the receiver is operated in a UFO®micro receiving system, the “UFO®micro” menu option must be set to “On”.
The receiving system then assigns the receiver a special address upon installation, so that it will recognise the control commands sent by the receiver to the receiving system for signal selection.
In this operating mode, a remote frequency need not be set, as it is specifi ed by the UFO®micro system with the addressing.
If the receiver is being used in a UFO®micro receiving system for the fi rst time, the address previously assigned must be deleted. This is done in the “UFO®micro” menu option by selecting “Reset” using the
and keys. The receiver is then assigned the original factory setting. It then needs to be set to “On” again. The receiver receives its new address from the new system.
Default setting: “Off”.
Factory Settings
This item allows all parameters to be reset to the factory settings using
the key. The factory settings do not necessarily correspond to the settings required for your specifi c system.
After resetting, you may need to make all settings again.
58
