Manual Lowering to Park Position
Manual Retraction
1.A plastic cover is located in the centre of the axis (see arrow). Lever this off with a narrow slotted screwdriver.
2.Behind the cover is an M8 hexagon head screw. Unscrew it using a socket wrench, size 13 mm
After removing the M8 screw, a further thread can be
seen.
3. Attention! Secure and support the antenna to prevent it tipping over. The connection to the rocker can suddenly come loose during the next step (point 4). It is then no longer connected to the turntable.
4 . Screw an M12 screw into this thread (minimum length: 22 mm) . You will need a socket wrench for this (size: 19 mm). Screwing in the M12 screw removes the rocker from the tapered shaft and releases the catch.
5.Tilt the antenna into park position (horizontal position).
6.Remove the M12 screw. This replaces the rocker on the tapered shaft.
7.Replace the M8 screw and tighten it
8.Replace the plastic cover.
Removing the rocker from the tapered shaft moves the position of the rocker zero point. An authorised dealer should eliminate this defect and calibrate the rocker.
9 . Consult an authorised dealer.
75
