Kenwood TH-255A ■Storing a Program Scan Frequency Range

1Press [VFO].

2Rotate the Selector (or press [UP]/ [DOWN]) to select the frequency outside of the Program Scan frequency range.

3Press [VFO] (1s).

•Scan starts at the current frequency.

•The 1 MHz decimal blinks while scanning is in progress.

•To reverse the scan direction, rotate the Selector clockwise (or press [UP]) <upward scan> or counterclockwise (or press [DOWN]) <downward scan>.

4To exit Band Scan, press any key other than [MON], [UP]/ [DOWN] or [].

Program Scan

You can limit the scanning frequency range. There are 3 memory channel pairs (L0/U0 ~ L2/U2) available for specifying the start and end frequencies. Program Scan monitors the range between the start and end frequencies that you have stored in these memory channels. Before performing Program Scan, store the Program Scan frequency range to one of the memory channel pairs (L0/U0 ~ L2/U2).

■Storing a Program Scan Frequency Range

1Press [VFO], then rotate the Selector (or press [UP]/ [DOWN]) to select your desired start frequency.

2Press [F], [MR] then rotate the Selector (or press [UP]/ [DOWN]) to select a memory channel from L0 ~ L2.

3Press [MR] to store the start frequency in the memory channel.

4Rotate the Selector (or press [UP]/ [DOWN]) to select your desired end frequency.

38