Kenwood TH-255A ■Using Program Scan

5Press [F], [MR] then rotate the Selector (or press [UP]/ [DOWN]) to select a channel from U0 ~ U2, corresponding to the channel selected in step 4.

•For example, if you selected L0 in step 3, select U0 for the end frequency.

6Press [MR] to store the end frequency in the memory channel.

■Using Program Scan

1Press [VFO], then rotate the Selector (or press [UP]/ [DOWN]) to select a frequency within the frequency range of memory channel L0/U0 ~ L2/U2.

2Press [VFO] (1s) to start Program Scan.

3To stop Program Scan, press any key other than [MON], [UP]/ [DOWN] or [].

Note:

◆If you press [MON], Program Scan temporarily pauses. Release [MON] to resume scanning.

◆The transceiver stops scanning when it detects a signal.

◆If more than 2 Program Scan channel pairs are stored and overlaps the frequency range among the pairs, the smaller Program Scan memory channel number has priority.

◆To perform Program Scan, the “L” channel must be lower than the “U” channel.

Memory Scan

1Press [MR] (1s).

•Scan starts from the last memory channel number and ascends up through the channel numbers (default).

•Rotate the Selector (or press [UP]/ [DOWN]) to change the scanning direction.

39