CONNECTIONS AND SETUP
Setting up the Screen
Position the projector perpendicular to the screen with all feet flat and level to achieve an optimal image.
Note
•The projector lens should be centered in the middle of the screen. If the horizontal line passing through the lens center is not perpendicular to the screen, the image will be distorted, making viewing difficult.
•For an optimal image, position the screen so that it is not in direct sunlight or room light. Light falling directly on the screen washes out the colors, making viewing difficult. Close the curtains and dim the lights when setting up the screen in a sunny or bright room.
•A polarizing screen cannot be used with this projector.
Standard Setup (Front Projection)
Place the projector at the required distance from the screen according to the desired picture size. (See page 22)
An Example of Standard Setup
Side View
90
•The distance from the screen to the projector may vary depending on the size of the screen.
•The default setting can be used, when placing the
projector in front of the screen. If the projected image is reversed or inverted, readjust the setting to “Front” for “PRJ Mode” in the “Options” menu.
Audience
Top View | • Place the projector so that an imaginary horizontal |
| |
| line that passes through the center of the lens is |
90 | perpendicular to the screen. |
H
12 V
12 H
V
Note
2D Lens Shift Ability:
•Short throw lens shift:
1/2 of screen height: Up 100%, Down 60%
1/2 of screen height: Left 15%, Right 15%
•Long throw lens shift:
1/2 of screen height: Up 140%, Down 60%
1/2 of screen height: Left 15%, Right 15%
•It is recommended that images be projected onto the dashed line octagonal area for fine image quality.
•There is a tolerance of 5% in the formula above.
21
