13 | 8 | 11 | 10 | 16 |
|
|
|
| |
9 | 12 |
|
| 14 |
|
|
|
|
15
18
8Service
9POD release latch — push up the POD release latch when you need to access the inside of the scanner.
10Output tray and end stop — collects the scanned documents. The output tray width and end stop length can be adjusted.
11Exit deflector — aids in document stacking.
12Printer access cover — lift this cover to access the front printer for changing printer positions and maintenance.
13Top access cover — lift this cover to access the rear printer for changing printer positions and maintenance.
14Touchscreen — a variety of functions can be performed using the touchscreen. See Chapter 3, Using the Scanner for procedures on using these functions. If you need to move the scanner, the touchscreen can be rotated so it will easily fit through doorways or tight spaces.
15LED — flashes green when the scanner is in Power Saver/Energy Star mode; LED is steady green when the scanner is idle and ready to scan.
16Workspace table height adjustment switch — used to raise and lower the workspace table on the scanner. The workspace table can be raised or lowered approximately 10 inches up or down.
17Height Adjustment Wire — located underneath the output tray (not shown in photo), this wire can be pulled out to raise the front of the output tray.
