Adjusting the height of the input elevator
Adjusting the input tray for document length
The input elevator can be set to accommodate stacks of
NOTE: In this document 25 will be referred to as the highest setting and 500 as the lowest.
Make this setting based on the number of documents you will place in the input elevator at one time.
When set to 25 (Document Feeder or Normal), the input elevator will remain in position. When set to 100, 250 or 500, the input elevator will automatically raise to feed documents and lower after the last document in your stack has been fed.
•No adjustments are required for documents up to 14 inches long.
•If you are scanning documents from 14 to 17 inches in length, open the input elevator extension.
•Documents longer than 17 inches require a document extender. Three sizes of document extenders are available for scanning documents from 43 cm (17 in.) to 86 cm (34 in.). See the section entitled, “Ordering parts” in Chapter 5 or contact your Kodak Field Engineer at
|
