Execute the print operation from your computer.

Control panel operations

6

 

Using the bypass tray

Use the procedure described below to print onto paper that is fed (one sheet at a time) from the bypass tray.

1 On your computer, display the “Setup” tab of the printer driver, and then specify “Bypass” for the Paper Source setting (page 5-16).

2

3 When the message LOAD PAPER appears on the machine’s display, load paper onto the bypass tray.

This causes the print operation to be performed using the paper from the bypass tray.

4 Repeat step 3 as many times as nec- essary until printing of the document is complete.

Note

Be sure to execute the print operation from the computer first, and then place the paper onto the bypass tray. If there is already paper on the by- pass tray when you execute the print operation, remove it, and then place it again onto the bypass tray.

Load the paper into the manual bypass tray one sheet at a time.

If the multi bypass tray (optional) is installed, it can used in the same way as any other paper tray since the multi bypass tray can hold 100 sheets of paper.

The multi bypass tray can be loaded with a maximum of 10 envelopes, 20 OHP transparencies, 20 postcards, 20 label sheets, or 100 sheets of plain paper.

Control panel operations Chapter 6

IC-205

6-7

Page 78
Image 78
Konica Minolta IC-205 manual Using the bypass tray