Lantronix LX6 Ip config-ip level commands, Line 1 line1 level commands, Baud rate bits per second

	5: Commands and Levels
no ip address	Clears the IP address.
no ipv6 address	Clears the IPv6 address.
no ipv6 default gateway	Clears the IPv6 default gateway.
no primary dns	Clears the name of the primary DNS server.
no secondary dns	Clears the name of the secondary DNS server.
primary dns <text>	Sets the IP address of the primary DNS server.
secondary dns <text>	Sets the IP address of the secondary DNS server.
show	Displays the current configuration.
show history	Displays the last 20 commands entered during the current
	CLI session.
show status	Show interface status
write	Stores the current configuration in permanent memory.
ip (config-ip) level commands
clrscrn	Clears the screen.
default ip time to live	Restores the default IP time to live.
default multicast time to live	Restores the default IP multicast time to live, which is one
	hop.
exit	Exits to the configuration level.
ip time to live <hops>	Sets the IP time to live, known by SNMP as
	"ipDefaultTTL".
	<hops> = number of hops that a typical IP packet is al-
	lowed to live.
multicast time to live <hops>	Sets the IP multicast time to live.
	<hops> = number of hops that a multicast IP packet is
	allowed to live.
show	Displays the current configuration.
show history	Displays the last 20 commands entered during the current
	CLI session.
write	Stores the current configuration in permanent memory.
line 1 (line:1) level commands
auto show statistics	Continuously displays line statistics.
baud rate <bits per second>	Sets the line speed.
	<bits per second> = the speed.
	Standard speeds include 1200, 2400, 4800, 9600, 19200,
	and so on.
clear line counters	Sets the serial counters to zero.
clrscrn	Clears the screen.
command mode always	Sets the current line to always be in command mode.
command mode echo serial string disable	Disables user-defined serial boot string to be echoed in
	the CLI.
command mode echo serial string enable	Enables user-defined serial boot string to be echoed in
	the CLI.
command mode serial string	Enables user to enter a custom string at boot time to enter
	command mode.
command mode serial string <string>	Sets a string that can be entered at boot time to enter
	command mode.
	<string> = text with possible binary characters.
	Within [] use binary decimal up to 255 or hex up to 0xFF.
	Within {} specify decimal milliseconds time delay.

XPort® Pro Lx6 Embedded Device Server Command Reference 77