Lenovo TS140 manual Installing or replacing the secondary hard disk drive, What to do next

5.Slide the new optical drive with the optical drive retainer the server until the optical drive snaps into position.

1

installed into the drive bay from the front of

Figure 41. Installing the optical drive

6.Reinstall the front bezel. See “Removing and reinstalling the front bezel” on page 38.

7.Connect one end of the signal cable to the optical drive and the other end to an available SATA connector on the system board. See “Locating parts on the system board” on page 15. Then, locate an available five-wire power connector and connect it to the SATA drive.

Figure 42. Connecting a SATA optical drive

What to do next:

•To work with another piece of hardware, go to the appropriate section.

•To complete the installation or replacement, go to “Completing the parts replacement” on page 79.

Installing or replacing the secondary hard disk drive

Attention: Do not open your server or attempt any repair before reading and understanding “Safety information” on page iii and “Guidelines” on page 35.

Chapter 6. Installing, removing, or replacing hardware 61