Lenovo TS140 manual Accessing the microprocessor, Removing the microprocessor

1.Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect all power cords from electrical outlets and disconnect all cables that are connected to the computer.

2.Remove the computer cover. See “Removing the server cover” on page 37.

3.Lay the computer on its side for easier access to the system board.

4.Locate the system board and disconnect all cables connected to the system board. See “Locating parts on the system board” on page 15.

5.Remove the heat sink and fan assembly. See “Replacing the heat sink and fan assembly” on page 69.

Note: Place the heat sink and fan assembly on its side so that the thermal grease on the bottom of it does not get in contact with anything.

6. Lift the small handle

1

and open the retainer

2

to access the microprocessor

3.

Figure 59. Accessing the microprocessor

7. Lift the microprocessor straight up and out of the microprocessor socket.

Figure 60. Removing the microprocessor

76ThinkServer TS140 User Guide