Console Port Information
Console is a standard UART interface to communicate with Serial Port. User can use windows HyperTerminal program to link the switch. Please refer to Console Management Æ Console login for detail steps.
Console port information shows as follow:
Bits per seconds: 9600
Data bits: 8
Parity: none
Stop Bits: 1
Flow control: none
Console Port Information interface
Port Controls
You can change the port status.
1.Select the port by scroll the list in Port column.
2.State: User can disable or enable this port control.
3.Negotiation: User can set auto negotiation mode is Auto, Nway (specify the speed/duplex on this port and enable
4.Speed: set the speed of each port.
5.Duplex: set
6.Flows control: set flow control function is ON or OFF in Full Duplex mode.
7.Back Pressure: set Back Pressure is ON or OFF in Half Duplex mode.
8.Band Width: The port1 ~ port 24, supports port ingress and egress rate control. For example, assume port 1 is 10Mbps, users can set it’s effective egress rate is 1Mbps, ingress rate is 500Kbps. The switch will perform flow control or Back Pressure to confine the ingress rate to meet the specified rate.
In: fill in the port effective ingress rate. The valid range is 0 ~ 1000. The unit is
72
