Lexmark Printer manual Page Control

2-64 PCL

Table 2-30: Page Control

Command / Parameters		Function / Result
ESC&l#A		Set Page Size
Paper		Selects the physical size of the paper, which also determines the
1	Executive	logical page dimensions. See the tables beginning on page 2-4for the
		paper and envelope dimensions your printer supports.
2	Letter
3	Legal	If the requested page size is not in the requested source or if no source
4, 10	Folio	is requested, sources are checked for the requested size in the
6, 11	Ledger (11 x 17)	following order: multipurpose feeder, tray 1, tray 2, tray 3, tray 4, tray 5,
13, 25	A5 Paper	and envelope feeder.
15	Statement	Notes:
26	A4 Paper
		• When the printer receives the page size command, any partially
27	A3 Paper
		formatted pages are printed, and the cursor position and margins
12, 45	B5 Paper
		are reset.
46	B4 Paper
		• Duplex printing is not supported on any envelope.
101	Custom Paper/Universal
		• The size loaded in the active source is checked to see if it matches
		the requested size. If the multipurpose feeder is configured as
Envelopes		Cassette or Manual, the same applies; however, if the multipurpose
80	Monarch 7 3/4	feeder is configured as First and media is loaded in the
		multipurpose feeder, then, regardless of media size, it is the source
81	Commercial 10
		used until it is empty.
89	Commercial 9
90	DL
91	C5
99, 100	B5 Envelope
600	Other Envelope
ESC&l#H		Paper Source
0	Active Source or Eject Page	Selects the paper feed source.
1	Tray 1 (Default)	Note: If the paper source is changed for the back of a duplexed page,
2	Manual Paper Feed
		a blank back page prints, the paper source changes, and the
3	Manual Envelope Feed
		information for the back side of the page is printed on the front side of a
4	Tray 2
		page sent from the new paper source.
5	Tray 3
6	Optional Envelope Feeder
7	Auto Select
8	Multipurpose Feeder
20	Tray 4
21	Tray 5
62	Optional Paper Source
ESC&f#G		Set Universal Width
# = number of Decipoints		Sets the width of the Universal size in decipoints.
(1 Decipoint = 1/720 inch)
ESC&f#F		Set Universal Height
# = number of Decipoints		Sets the height of the Universal size in decipoints.
(1 Decipoint = 1/720 inch)