Lexmark Printer manual Font Creation, Macros

2-73 PCL

Table 2-35: Font Creation

Command / Parameters		Function / Result
ESC*c#D		Set Font ID
# = Font ID # (0 - 32767)		Sets the identification number for the font being downloaded.
Default = 0
ESC)s#W[data]		Load Font Header
# = number of data bytes		Downloads soft font header information.
		Note: Set Font ID before using this command.
ESC*c#F		Caution: Font Control
0	Delete all (temporary and permanent)	Manages soft fonts.
1	Delete all temporary
2	Delete previous font ID
3	Delete previous specified character
4	Make previous font ID temporary
5	Make previous font ID permanent
6	Copy current font
ESC*c#E		Set Character Code
# = Code Point (0 - 65536)		Sets the decimal code point associated with the next character
Default = 0		downloaded or deleted.
ESC(s#W[data]		Load Character
# = number of data bytes		Downloads character descriptor and data to the current character
		code.

Table 2-36: Macros

Command / Parameters		Function / Result
ESC&f#Y		Set Macro ID
# = Macro ID (0 - 32767)		Sets the ID for the macro you have created on flash or disk.
Default = 0
ESC&f#X		Macro Control
0	Start definition	Manages use of macros.
1	End definition	Notes:
2	Execute macro (previous macro ID)
		• GL/2 commands are supported inside macros.
3	Call macro (previous macro ID)
		• Only call and execute macro commands are allowed within a macro.
4	Enable overlay (previous macro ID)
		• A macro may call or execute another macro. This is called nesting. A
5	Disable overlay
		maximum of two nesting levels are allowed, for a total of three
6	Delete all macros
		levels.
7	Delete all temporary macros
		See “Macros” on page 2-95 for additional information.
8	Delete current macro ID
9	Make last ID temporary
10	Make last ID permanent