Split System Models
Figure 27 3 ton centrifugal air cooled condensing unit (con't.)
Single- or
not by Liebert
| Optional | |
| disconnect switch | |
| ||
Line voltage electric power | to components | |
on electric panel | ||
supply conduit entrance | ||
|
Single- or
not by Liebert
Connection terminal for
Heat rejection connection.
Class 2 wiring. See NOTE 2.
Wire connections from evaporator |
| DPN000207_Rev0 | |
mod: |
| ||
1. | 24V ground |
|
|
2. | 24V supply | NOTES: | |
3. | |||
4. | Hot gas bypass connection | 1. | Refer to specification sheet for full load amp. and wire size amp. ratings. |
| (only on units with hot gas | 2. | Control voltage wiring must be a minimum of 16 GA (1.6mm) for up to 75' (23m) |
| bypass) |
| or not to exceed 1 volt drop in control line. |
56
