Split System Models
Figure 32 3 ton water/glycol cooled condensing unit (con't.)
Single- or | |
switch when optional disconnect | |
service not by Liebert | is not provided in unit |
| |
| wiring to fan/coil unit |
| |
| Class 1 wiring to drycooler |
|
Earth/ground connection
Connection terminal for
Line voltage electric poweron electric panel supply entrance
Optional
Remote drycooler connection | Heat rejection connection. | DPN000209_Rev0 | |
Terminals 70 & 71 supplied for |
| ||
connection to remote drycooler |
| ||
Wire connections from evaporator mod: |
| ||
Use |
| ||
1. | 24V GND |
| |
Class 1 wiring |
| ||
2. | 24V supply |
| |
units only) |
| ||
3. | High pressure alarm (opt) |
| |
|
|
4. Hot gas bypass connection (only on units with hot gas bypass)
NOTES
1.Refer to specification sheet for full load amp. and wire size amp. ratings.
2.Control voltage wiring must be a minimum of 16 GA (1.6mm) for up to 75' (23m) or not to exceed 1 volt drop in control line.
62