Lightwave Communications 3200 user manual Status Commands, CONNECTIONS Command

sys admin>>MODEM

Enter accepts present value Init string > ATB2H0

Save changes and update modem card? Yes or No: No>yes Modem card not installed in slot A, init string saved

Sys admin>MODEM /DEFAULT

Current modem init string is: ATB2H0

Set modem to factory default value of: ATH0S0=1

(write out YES) Yes or No: No>yes

Modem card not installed in slot A, init string saved sys admin>>

The sys admin may also reset the initialization string to the default value by entering the command with the default qualifier in the form MODEM /DEFAULT. When using the /DEFAULT qualifier, the current initialization string is displayed, along with the factory default string. The sys admin is asked to confirm the use of the default modem string; typing YES and <ENTER> will send the default initialization string immediately to the modem card, while typing NO and <ENTER> keeps the old modem string.

It is recommended that the default modem initialization string be used unless the application requires that it be changed. The default initialization string is ATH0S0=1, which disconnects any active phone connections when the initialization string is sent, and sets the modem to auto-answer on one ring.

6.7Status Commands

There are six commands which allow the sys admin to check the status of the ConsoleServer 3200: CONNECTIONS, LISTCARDS, VERSION, INFO, POWERSTATUS and LOG.

6.7.1CONNECTIONS Command

The sys admin may monitor the status of connections made through the terminal cards by using the CONNECTIONS command. This command will display all the active connections and the mode of those connections as follows:

32