LINDY CPU IP Access Switch | User Manual |
Customization
An explanation of the customization settings is given in the table, below:
| After obtaining new versions of the firmware, specify the directories that you | |
Uploads | have put them in here to start the firmware upgrade procedure (see p. 23 for | |
| details). | |
|
| |
Time out Control | If the CPU IP ACCESS SWITCH doesn’t receive any input from the computer | |
that currently has access to it for the amount of time specified here, it ends | ||
| the connection so it can be available for other users. | |
|
| |
| Login failures allowed, sets the number of consecutive failed login attempts | |
Login failure | that are permitted from a remote computer. Login failure timeout, sets the | |
amount of time a remote computer must wait before attempting to login again | ||
| ||
| after it has exceeded the number of allowed failures | |
|
| |
| If Stealth Mode is enabled, the CPU IP ACCESS SWITCH cannot be pinged. | |
Working Modes | If Echo Mode is disabled, the CPU IP ACCESS SWITCH will not show up in | |
| ||
| the list of local CPU IP ACCESS SWITCH units (see p. 11 and p. 27) | |
|
| |
| Placing a check here causes the CPU IP ACCESS SWITCH to reset itself and | |
Reset on exit | implement all the new changes when you Click OK and close the Settings | |
Notebook. Otherwise settings changes will not take effect until the CPU IP | ||
| ||
| ACCESS SWITCH is manually reset. | |
|
|
22
