Lucent Technologies 1100 2-16 Issue 1 June 1998

Configuration

2-16 Issue 1 June 1998

1. While online, press HOLD button four times.

Disconnect is displayed.

2. Press 3 until screen displays Set PBX COM port.

3. Press 2 to change Switch Module parameters. Selections

available are: Data Rate, Data Bits, Parity, and Stop Bits.

NOTE:

Refer to the DEFINITY Extender 1101 System manual for

more information on how to configure the Switch Module’s

COM port while online with the Remote Module.

Contents

Main Page Page Customer Support Information About This Book ii 1 2 3 4 Page Figures Tables Page viii WARNING: SAVE THESE INSTRUCTIONS Page x Security of Your System: Preventing Toll Fraud Lucent Technologies Fraud Intervention xii Lucent Technologies Limited Warranty FCC Notification and Repair Information xiv Installation and Operational Procedures Federal Communications Commission (FCC) Electromagnetic Interference Information Page About This Book Intended Audience xviii Terms and Conventions Security Alert: Typographical Conventions How to Use This Book xx Product Safety Labels WARNING: CAUTION: Related Documents xxii Page Page THIS FORM MAY BE PHOTOCOPIED Introduction 1-2 Issue 1 June 1998 System Operation and Configuration Page Page Compatibility 1-6 Issue 1 June 1998 Options Specifications Page 1-8 Issue 1 June 1998 Considerations 1-10 Issue 1 June 1998 Configuration Password Considerations 2-2 Issue 1 June 1998 Programming the Switch Module Page 2-4 Issue 1 June 1998 The Enhanced Terminal Interface The Terminal Edit Line 2-6 Issue 1 June 1998 Configuring the COM RS-232D Port Page 2-8 Issue 1 June 1998 Setting Data Rate Setting Parity Setting Data Bit Page 2-10 Issue 1 June 1998 Setting Passwords 2-12 Issue 1 June 1998 Considerations Programming Passwords Procedure 2-14 Issue 1 June 1998 Configuring Passwords Online Configuring the PBX COM RS-232D Port from the Remote Telephone 2-16 Issue 1 June 1998 Page Page 3-2 Issue 1 June 1998 Location Requirements Electrical Requirements Wiring Requirements Connecting the Switch Module 3-4 Issue 1 June 1998 Installation Procedure Page 3-6 Issue 1 June 1998 Connections for Data Transmission 3-8 Issue 1 June 1998 Female Connector on Module Hardware Flow Control Page Page 4-2 Issue 1 June 1998 Troubleshooting LED Sequences 4-4 Issue 1 June 1998 LED Sequence Description 4-6 Issue 1 June 1998 Page 4-8 Issue 1 June 1998 Error Messages Page 4-10 Issue 1 June 1998 Specific Problems No Display on Telephone at Remote Location No Connection/No Answer b. Use a regular telephone to get dial tone on the CO line c. Check the cables at the Switch Module. d. Module. 4-12 Issue 1 June 1998 Reporting a Faulty Switch Module Page Glossary Glossary GL-2 Issue 1 June 1998 D F Page Glossary GL-4 Issue 1 June 1998 R RS-232D (EIA/TIA-574 Interface Circuits) PIN EIA DESIG CCITT DESIG DESCRIPTION DIRECTION S